ICC 7529 Fluorescent Lemon Ultramix Direct Print Plastisol Ink is a specially formulated high performance, low bleed plastisol designed for ultra high speed wet-on-wet automatic printing. It's a very creamy and short bodied ink with low tack, and for ease of printing, a greatly improved shear. Well suited for fine detail and halftone printing using finer mesh counts. Get faster production speeds with less pressure, and extremely resistant to ink build-up.
Need less than a gallon? Get Merchmakr Electric Orange Screen Printing Ink!
|Recommended Fabrics||Light colored 100% cotton or some cotton/polyester blends. Use an underbase for dark fabrics. Always test print fabric before beginning a production run.|
|Ink Application||Colors should be printed without any modifications. If thinning is required, use 1099LF LB Lo-Bleed Reducer (1% to 5% by volume).|
|Screen Mesh and Emulsion||110 to 305 t/in or 43 to 120 t/cm Monofilament Any direct or indirect lacquer resistant emulsion. Use 35 to 70 micron capillary film for best results.|
|Cure Temperature||325° (163°C) Entire ink film. Test dryer temperatures and wash test printed product before and during a production run.|
|Clean Up||Press Wash will clean the ink out of the screen for color changes or library storage. When taking out the screens entirely, ink degradent is recommended to break down the ink into a drain-safe form.|
|Storage||Keep containers out of extreme heat or cold. Recommended storage at 65-90ºF. Avoid storage in direct sunlight and moist, humid air.|
The 7500 Series inks will spot dry, with very low after flash tack, in 3 to 8 seconds depending on the spot dryer used. Too much heat / time may cause the ink to become sticky after flashing. Adjust flash unit accordingly. When spot drying, the ink should be just dry to the touch, with no lift off, but not totally fused. Totally fusing any of the flashed colors may cause inter-coat adhesion problems with the inks printed on top of the flashed ink. Final curing Ifusing will occur in the dryer.